Increase the separation between We equipment and receiver.Reorient or relocate We receiving antenna.If this equipment does cause harmful Interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Interference by one or more of We following measures: However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, If not Installed and used in accordance with the instructions, may cause harmful interference to ratio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful Interference, and (2) this device must accept any interference received, Including Interference Wat may causa undesired operation Warning: Changes or modifications to this unit not expressly approved by We party responsible for compliance cold void We user’s authority to operate the equipment. This device complies with Part 15 of the FCC Riles. Please refer to your local and state laws for battery disposal procedures. Lithium polymer batteries are environmentally safe when fully discharged. This product contains a lithium polymer battery. Improper repairs may place the user at serious risk. Repairs to the electrical equipment should only be preformed by a qualified electrician.Do not use this unit If It has been dropped or damaged In any way.Do not operate the unit if if has been wet or moist to prevent against electric shock and/or injury to yourself and damage to the unit.Do not expose the device to extremely high or low temperatures, as It may damage the battery.Keep the unit away from heat source, direct sunlight, humidity, water or any other liquid.Do not use this unit for anything other than its intended use.The LED on the bottom of the case will turn white Once fully charged, the LEDs on earbuds and case will turn off. The LEDs will turn solid red while charging. Place the earbuds into their respective slots In the charging case. Once fully charged, LED will Illuminate solid green.ĬHARGING THE EARBUDS – When the earbuds are low in power, you will hear ‘Battery Low”. The LED Indicator will Illuminate to confirm both are connected and charging.ĬHARGING THE CASE – Plug the standard Micro-USB charging cable into the port on the case and connect the USB head to a power source, such as an AC wall adapter or computer. Make sure to fully charge the earbuds prior to the first use Please note: If you are only using one earbud and the second one Is fully charged in the case, be sure to remove It prior to inserting the second one. This function may network with all devices. Press the RIGHT or LEFT earbud button twice to activate/exit the Voice Assistant/Siri function. REWIND / PREVIOUS SONG – Press and hold the LEFT earbud button. NEXT SONG – Press and hold the RIGHT earbud button. PLAY / PAUSE – Press the RIGHT or LEFT earbud button one time. REJECTING A CALL – Press and hold the RIGHT or LEFT earbud button during an Incoming call. CALLING / MUSICĪNSWER/END CALL – Press the RIGHT or LEFT earbud button once during an Incoming call to answer, or press during a call to end. Your Probuds are now ready to use! SINGLE EARBUD USAGEĮach earbud can be used independently.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |